LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

LV RunTime: "vi is broken or one of it's subVIS can't be located"

I made a deployment image in TST 2010 DE. I used the LV2011 disk to copy the LV RT images. In the config the RT engine was set to LV2010.

 

I wrote the test vi in LV2011. Then I added it to a lvlib and then loaded it in TST. This ran under the DE from TST and LV. Then I made the deployment.

The test vi was under version 2011 and it resided some custom controls, spreaded across different directories on the network drive.

0 Kudos
Message 21 of 27
(417 Views)

When I use the "FP.winbounds" property in my vi the RT2010 reports a broken vi? When I remove this property it runs.

0 Kudos
Message 22 of 27
(406 Views)

Forget my last reply. I can't write to winbounds at RT.

0 Kudos
Message 23 of 27
(403 Views)

Can I use cvt with the RT engine? It's better I install the DE?

0 Kudos
Message 24 of 27
(399 Views)

CVT is supported by the Full Development System. I am not sure if the functionality is extended to CVT. You'll have to check on it. But since you are extensively using LabVIEW, why dont u go ahead and install the DE?

 

Regards,

Prashanth N
National Instruments
0 Kudos
Message 25 of 27
(397 Views)

Tnx Pachi,

 

 

I think it's a good idea. 🙂

0 Kudos
Message 26 of 27
(395 Views)

Glad I could be of help 😉

 

Regards,

Prashanth N
National Instruments
0 Kudos
Message 27 of 27
(393 Views)