09-05-2011 08:25 AM
I made a deployment image in TST 2010 DE. I used the LV2011 disk to copy the LV RT images. In the config the RT engine was set to LV2010.
I wrote the test vi in LV2011. Then I added it to a lvlib and then loaded it in TST. This ran under the DE from TST and LV. Then I made the deployment.
The test vi was under version 2011 and it resided some custom controls, spreaded across different directories on the network drive.
09-06-2011 01:46 AM
When I use the "FP.winbounds" property in my vi the RT2010 reports a broken vi? When I remove this property it runs.
09-06-2011 02:20 AM - edited 09-06-2011 02:22 AM
Forget my last reply. I can't write to winbounds at RT.
09-06-2011 03:17 AM
Can I use cvt with the RT engine? It's better I install the DE?
09-06-2011 03:48 AM
CVT is supported by the Full Development System. I am not sure if the functionality is extended to CVT. You'll have to check on it. But since you are extensively using LabVIEW, why dont u go ahead and install the DE?
Regards,
09-06-2011 03:57 AM
Tnx Pachi,
I think it's a good idea. 🙂
09-06-2011 04:09 AM
Glad I could be of help 😉
Regards,