09-11-2019 06:28 AM
Hello all,
I am trying to send ID to some ecu, and waiting for response.
VI is in attachment.
Device NI USB 8476.
I successfully send the ID as header, which I proved with oscilloscope.
At the end of LIN wire, there is not any ECU yet, but unfortunately I get some data as response. I assume that nothing should be read...or at least array with 0.
Can someone take a look and advise how to overcome this issue?
Best regards.
09-12-2019 04:36 PM
Hi milan87,
I would post your question at the more focused discussion board below to get proper eyes on your issue:
AUTOMOTIVE AND EMBEDDED NETWORKS
https://forums.ni.com/t5/Automotive-and-Embedded-Networks/bd-p/30