Knob Control with hex values for the scale

[altenbach]

Yes, I can also confirm this to be be a bug in 8.2.1.

Another curiosity:

If you go to the "advanced editing mode", the %02x format (for example) is valid, but if you e.g. delete the x and then put it back, it claims the format is invalid . same for octal and binary formats.

Clearly a bug!

(reported: http://forums.ni.com/ni/board/message?board.id=BreakPoint&message.id=3918#M3918 )

Message Edited by altenbach on 07-09-2007 12:05 PM

[Kaspar]

I am using 8.2 and the properties menu does not let me set a hex format for the knob scale

[Craig_D]

This was reported to R&D (# 4B9C05LJ) for further investigation.  The suggestion of creating a property node from the control and setting the scale->format property manually should be a good workaround for now. 

Thanks for the feedback!

Craig D

Applications Engineer

National Instruments

[Roy_F]

---

@craig D wrote:

This was reported to R&D (# 4B9C05LJ) for further investigation.  The suggestion of creating a property node from the control and setting the scale->format property manually should be a good workaround for now. 

Thanks for the feedback!

Craig D

Applications Engineer

National Instruments

---

CAR ID is actually 4B9D5HLJ.

Roy