I just received a cRIO-9073 and a cRIO-9074.
When I configure them, both of them appear properly in MAX.
When I add them to a LabVIEW project, the cRIO-9073 does not show its FPGA target. The cRIO-9074 does show it.
I am using LabVIEW 8.5.1, is it compatible with the cRIO-9073?
Thanks for any help.
Solved! Go to Solution.
According to the following link, the FPGA and Scan interface of the cRIO 9073 are only supported in LV 8.6 using the driver NI-RIO 3.0.
The link where you can check compatibility is:
Have a nice day!
Thank you very much for the very prompt response. This should solve my problem.
Also, after I read you message, I finally found the link to the software revision/compatibility file in the CompactRIO cRIO-9072/3/4 Operating Instructions and Specifications on page 3:"Notes Visit ni.com/info and enter the info code rdsoftwareversion to determine
which software you need to use the cRIO-9072/3/4."
Thanks again for your help