I cannot build an installer for my program

[User321]

I have no device drivers disk. I downloaded everything from the NI website.

[User321]

I have both the Visa and the 488 installed. I even went to NIs website this morning to install them again, just in case, but the NI utility said that the latest version was already installed.

If I need to tell LabView where the 488 and Visa drivers are, where do I tell it to look?

[User321]

Unfortunately I can not post the project. It contains proprietary information

[Dennis_Knutson]

Pay attention. You must copy the actual installer, not just install the driver. Once you have a local copy, when prompted, just browse to the location if you choose anything other than the default.

[User321]

I am paying attention. If you will see, I do not know which installer it wants. It does not tell me which installer. Even if it did, where do I find the installer?

If you haven't been able to figure it out by now, I am new to LabView and do not know all of the intricate in's and out's that is required. If I did, I wouldn't need to ask for help from the forum.

LabView want's me to tell it where some installer is, but it does not tell me which one. How can I know what it wants?

I have attached again the screen that I am getting. All LabView is telling me is that it wants system components. What system components? I do not know. It does not tell me.

[Gregory]

Can you strip out anything proprietary and post the zipped up project?

[Dennis_Knutson]

What does your additional installers screen look line before you start the build?

[User321]

I have attached screen shots of the additional installers screen

[aaronb]

When creating your installer under the Category "Additional Installers" select the check boxes next to your Labview Runtime Version and also anything "NI-488.2" (GPIB) related and also anything "NI-VISA" related. If you want NIMax in order to see you VISA ports and GPIB controller select "NI DAQmx Runtime" and "NI DAQmx Runtime w/ Configuration Support" .

On newer versions of Labview there is a check box at the top of the "Additional Installers" window for "Automatically select recommended installers" but I have seen that not work 100% of the time.

[User321]

I have done that, but I am still getting the same message.