LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

I can't select my COM port

Solved!
Go to solution

Hi all,

I can't select my com port on linx firmware wizard beacuse of that I can't use my arduino mega2560 with LabView 2013(64 bit) if someone can help me, I will be pleased with help
thankyou

0 Kudos
Message 1 of 9
(6,547 Views)

So, on which com port is your device connected?

0 Kudos
Message 2 of 9
(6,518 Views)

com 1 is the slot I used but I can't find on Labview at the sametime on arduine I already can select the port

0 Kudos
Message 3 of 9
(6,493 Views)
Hi, Check in NI MAX. It must detect over there in Devices and interfaces
Venugopal
0 Kudos
Message 4 of 9
(6,470 Views)

I couldn't find, can you explain exactly way step by step ?

thankyou 🙂

0 Kudos
Message 5 of 9
(6,435 Views)

Have you already installed the NI VISA driver from the link below?

 

https://www.labviewmakerhub.com/doku.php?id=learn:tutorials:libraries:linx:getting_started

Andrew B.
Application Engineer
National Instruments.
http://www.ni.com/support
0 Kudos
Message 6 of 9
(6,415 Views)
Hi, You need to install device drivers you can find them in NI site
Venugopal
0 Kudos
Message 7 of 9
(6,379 Views)
Solution
Accepted by Vidocq

@Vidocq wrote:

com 1 is the slot I used but I can't find on Labview at the sametime on arduine I already can select the port


This makes me think you are running Arduino IDE at the same time as LabVIEW, and the hardware might be locked by the software.  If LabVIEW is the only thing running, does it see your COM port?  Did you try reinstalling or repairing NI-VISA?

Message 8 of 9
(6,363 Views)
Solution
Accepted by Vidocq

Thankyou so much guys I fixed my problem with visa like you said you guys the best

0 Kudos
Message 9 of 9
(6,347 Views)