06-10-2011 03:33 PM
Hi,
I want to send an output signal from a simulink model to a DAQ card using the LabView Simulation Interface Toolkit 2009. I think I need to use the Hardware i/o menu in the SIT connections manager but this one is non clickable.
So, how can I send the signal without using the Hardware i/o menu or how can I access this menu?
Thanks
Regards
Simon W. Kirouac
CSA Coop Student
06-13-2011 08:41 PM
Hello,
I am unsure by what you mean about an item not being clickable but below are instructions on how to create mappings for a DAQ device in SIT as well as another article on creating a user interface for a model.
Creating Mappings for a National Instruments DAQ Device (Simulation Interface Toolkit)
http://zone.ni.com/reference/en-XX/help/371504F-01/lvsithowto/sit_h_ni_daq/
Building a LabVIEW User Interface for a Simulink® Model with LabVIEW Simulation Interface Toolkit
http://zone.ni.com/devzone/cda/tut/p/id/3057
Hope this helps.
Regards,
Patricia B.