07-28-2016 01:51 PM
Hello, I have some older code examples for an sbRIO where the wire data type into the FPGA IO node for Analog Out is I16. I would like drive my 9637 outputs the same way, but they appear as FXP terminals with a +/- 10 range. I did not find properties settings that allow me to change to using raw bits, can someone point me to that option? I understand there are some nice calibration aspects of the FXP data type but in this case I would like to try using I16 to drive the 16 bit analog outs.
Thanks,
JEB
07-29-2016 02:06 PM
Hello JesseBuck,
Thank you for the question. I wanted to link you to another thread which shows how to do this with our sbRIOs using C series modules. Like you noticed however, this option does not exist for the Connector0 analog inputs or outputs and may not be supported.
Did your previous sbRIO use any C series modules with a RIO Mezzanine Card? Which model sbRIO was this?
The discussion mentioned above for reference:
Real-Time Measurement and Control Forums - Change Data Type for FPGA I/O Node
07-29-2016 03:54 PM
OK, thanks. I had looked at the AOn properties but the outputs are not offering me any choices, so I guess that settles it!
JEB