10-01-2012 08:35 PM
I have a smoke alarm EI100b, i need it to connect to labview. When the smoke alarm activate the labview will show an output message. By the way im also using the NI ELVIS 2+. Thx
10-01-2012 09:00 PM - edited 10-01-2012 09:04 PM
Does it have any kind of relay contact you can interface with?
10-01-2012 09:02 PM
No. Is it possible to do so?
10-01-2012 09:03 PM - edited 10-01-2012 09:04 PM
You need to contact the manufacturer of the smoke detector to see if there is anyway to interface with it.
10-01-2012 09:12 PM
Is any kind of relay able to help cause i have one. If it is possible how am i able to do it. Once again thanks for ur help
10-01-2012 09:14 PM - edited 10-01-2012 09:42 PM
duplicate post....again, try looking on the PCB for an IC switch(i.e., transistor, mosfet,voltage comparator, driver....)then take a voltage differential. You can do your part by naming the IC's(U#) or transistors(Q#) on the board. btw, show us your VI and what you have done so far?