07-14-2016 03:31 AM
I have created the piece of code required to change the timebase and time delay settings on the oscilloscope and then convert the waveform to a spreadsheet file. However, because the code is in a while loop, the settings keep getting updating, thus throwing everything off.
Is there any way I can change the settings on the DSO1024 Oscilloscope manually and then use the code to take the measurement?
07-14-2016 03:48 AM
Hi Kghangas,
because the code is in a while loop, the settings keep getting updating, thus throwing everything off.
You could change your code to do those settings just once, before the loop…
Is there any way I can change the settings on the DSO1024 Oscilloscope manually and then use the code to take the measurement?
Does the scope understand commands to en-/disable the keyboard like most other (better) devices? Use them!
03-16-2018 10:01 AM
I have a DSO1024 oscilloscope and I could't acquire the channels waveform's in LabVIEW via USB connection. Could you please help me with that?
03-16-2018 10:26 AM
@HussainSayed wrote:
I have a DSO1024 oscilloscope and I could't acquire the channels waveform's in LabVIEW via USB connection. Could you please help me with that?
That has nothing to do with this topic. Start a new thread, preferably in the Instrument Control board.