I am using an ActiveX control to read an EPICS channel: I use AutomationOpen to get a ref # to my ocx control, then use a flat sequence to: Add a channel, check it is connected, read something on that channel, each one by calling methods in my ActiveX control, then close the reference.
If I single step, or run the vi with the Hi-light bulb enabled, everythinng works as supposed, and I get a readback value off my equipment. When I try and run it normally (Hi-light bulb off), the vi runs, but does not really do anything: the indicator shows the channel is not connected, and it doesn't read any value. I checked already to see if there's an inadvertently braekpoint set, or pause button checked, and everything is as it should be.
I'm
at a loss. Any ideas ?
Thank you
Larry T.