LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

HP34401A DMM Local Mode?

After taking a measurement, I would like to put my DMM back into Local
mode via GPIB. (I'm tired of physically pressing the button myself.)
How do I do this? I've tried sending GTL, but it didn't work. Also I
tried loc ##, where ## is the GPIB address. I use LV6. Thanks for any
input.
0 Kudos
Message 1 of 2
(2,379 Views)
In the 488.2 commands is a enable local command.
You have to supply an address list (array of addresses)
and these instruments will go back to local again.
greetings from the Netherlands
0 Kudos
Message 2 of 2
(2,379 Views)