LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

HELP! Fresh install of LabVIEW; Serial driver not working.

Solved!
Go to solution

I recently had a catastrophic failure of my PC and was forced to reinstall all my programs. Since then, my LabVIEW program fails to wake my serial driven devices. 

While sending an array of wake characters, the display shows these '\' codes as squares. It seems to get no meaningful feedback from my device. I can communicate with the device in all the normal ways using a terminal. I think I've installed all the packages that were previously installed, but I don't have a good way of knowing for sure. Am I missing something? 

 

The picture shows my '\' codes on the left, and the output on the right.

 

 Capture.PNG

0 Kudos
Message 1 of 2
(600 Views)
Solution
Accepted by topic author JEWalter

NEVERMIND! 
It turns out my program wasn't setting the COM port correctly.  Facepalm. 

Thanks!

Message 2 of 2
(579 Views)