09-28-2014 10:35 PM - edited 09-28-2014 10:36 PM
here i list out all ip port on my pc. and i also attached the ip address from the TDS3012C
09-28-2014 11:00 PM
You need to go into the IP address setting of your ethernet adapter, set it to static, and set it to 10.61.66.1 Set the gateway to that, and the subnet mask to 255.255.255.0
Right nown it looks like you have 3 different hardwired ethernet adapters. But since they are all showing a 169.x.x.x address, that means they aren't on a network, and they are all set for dynamic addresses and looking for a network to join.
09-28-2014 11:04 PM
09-28-2014 11:06 PM
No.
i want it dedicated to my pc. if you not recommend a dhcp configuration. what should i do then?
09-28-2014 11:11 PM - edited 09-28-2014 11:11 PM
Set your IP address for the ethernet adapter (on the PC) to be a static address like it has been said several times before.
09-28-2014 11:19 PM - edited 09-28-2014 11:22 PM
sorry sir
do i have to do as attached
Once i hace change into static ip address, then i have to change the ip address in the scope same as the pc address?
09-28-2014 11:56 PM
09-29-2014 12:15 AM
Ok sir. i think i got you
1: set static ip adress on my pc (eg: 192.168.1.1)
2: next configure scope with DHCP off. insert 'instrument ip address:192.168.1.1)
do i have to change my gateway ip address?
i followed through this article but my pc cannot detect from the scope - http://www.ni.com/white-paper/7301/en/
09-29-2014 12:20 AM
09-29-2014 12:36 AM
Sorry sir.
i did that as the tutorial in the link.
Intrument IP: 192.168.1.1
Dns IP :
Gateaway IP:
for the DNS and Gateaway IP - is it leave it blank?
PC SETTING
Ip address: 192.168.1.2
is it like this?
i am new to this device and dunno nothing about it.
hope you can bear with me for few months