LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Facing problem

Highlighted

Hello,

        I am new in using labview , i am using labview 2010 but for some reasons my front panel is not showing the options of 'signal processing' and 'control design & simulation'

Please help me to solve this issue

Thanks

0 Kudos
Message 1 of 6
(1,238 Views)
Highlighted

Front Panels show Controls and Indicators, the Block Diagram shows functions and wires, and is where you would look for Signal Processing and functions in the CDS Toolkit.  Type Ctrl-E and look in the Block Diagram.

 

Bob Schor

0 Kudos
Message 2 of 6
(856 Views)
Highlighted

🙂 It looks like not only me got tricked by these "walking dead" posts from the past 😄

0 Kudos
Message 3 of 6
(850 Views)
Highlighted

Oops.  It's probably going to hit a lot of us who are "regulars" ...

 

BS

0 Kudos
Message 4 of 6
(835 Views)
Highlighted

@Bob_Schor wrote:

Oops.  It's probably going to hit a lot of us who are "regulars" ...


I just did a "Mark All As Read" last night when I saw a lot of last posts from 2012.  It looks like things are back to normal for me after that.


GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
0 Kudos
Message 5 of 6
(819 Views)
Highlighted

@crossrulz wrote:


I just did a "Mark All As Read" last night when I saw a lot of last posts from 2012.  It looks like things are back to normal for me after that.


Thanks for the suggestion.  Of course, it took me a minute or two of "looking around" before I found that option ...

 

Bob "Growing Pains are the Pits" Schor

0 Kudos
Message 6 of 6
(807 Views)