12-03-2012 09:13 AM
Hello,
I am new in using labview , i am using labview 2010 but for some reasons my front panel is not showing the options of 'signal processing' and 'control design & simulation'
Please help me to solve this issue
Thanks
11-21-2016 02:45 PM
Front Panels show Controls and Indicators, the Block Diagram shows functions and wires, and is where you would look for Signal Processing and functions in the CDS Toolkit. Type Ctrl-E and look in the Block Diagram.
Bob Schor
11-21-2016 03:00 PM
🙂 It looks like not only me got tricked by these "walking dead" posts from the past 😄
11-21-2016 10:11 PM
Oops. It's probably going to hit a lot of us who are "regulars" ...
BS
11-22-2016 06:32 AM
@Bob_Schor wrote:Oops. It's probably going to hit a lot of us who are "regulars" ...
I just did a "Mark All As Read" last night when I saw a lot of last posts from 2012. It looks like things are back to normal for me after that.
11-22-2016 07:18 AM
@crossrulz wrote:I just did a "Mark All As Read" last night when I saw a lot of last posts from 2012. It looks like things are back to normal for me after that.
Thanks for the suggestion. Of course, it took me a minute or two of "looking around" before I found that option ...
Bob "Growing Pains are the Pits" Schor