LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

FREQUENCY SWEEP SIMULATION ISSUES

Hello,

 I have been trying to simulate two speed signals with the following specification. I have tried other labview forums but this particular one has been very helpful to me.

Signal 1:

Maximum amplitude:    5V

Minimum amplitude:     12V

Form:                                    Sinusoidal

OP Impedance:                 ~100 Ohm

Switchable:                         8Hz or 800Hz

 

Signal 2:

Maximum amplitude:    5V

Minimum amplitude:     12V

Form:                                    Sinusoidal

OP Impedance:                 ~100 Ohm

Adjustable over:              8Hz to 1000Hz

Soft switchable sweep: 800 Hz rising @ 7% per second

                                                800 Hz rising @ 9% per second

                                                800Hz rising @ 11% per second.

I have implemented the first part. For the second one,  I have used the formula for the sweep, taking the 7% per second as an example.

From v = u + at where v is freqency, and then integrating:

800Hz to 1.07*800:                          800 + 56t

856 Hz to 1.07*856;                         856 + 59.2t

915.92Hz to 980.0344;                915.92 + 980.0344t

sin((800* t) + ((56*t*t)/2))+sin((856* t) + ((59.2*t*t)/2))+sin((915.92* t) + ((980.0344*t*t)/2))

 I have tried simulating two portions of this sine wave. But I cannot implement the whole thing on a single waveform.

Please help. I have attached the Vis for 1 and a trial for the second one.

 

Thanks.

0 Kudos
Message 1 of 3
(1,363 Views)

Hi maxidivine,

 

Thank you for using the National Instruments forum. I have noticed you have published the same question multiple times. Please use one forum thread. For this, can we keep everything within the forum - http://forums.ni.com/ni/board/message?board.id=170&message.id=421097

 

Kind regards,
Ashish Naik
Automotive Business Development Manager
National Instruments UK
0 Kudos
Message 2 of 3
(1,333 Views)

Thank you very much for the clarification and advice.

 

I am grateful.

0 Kudos
Message 3 of 3
(1,324 Views)