FPGA Application not running on CRio-9045

[bill0w]

Hi,

I did a simple VI to read and write Digital inputs/outpus with fpga mode on Crio-9045, but it didn't work ( I can't see switching inputs and there isn't an error, even i wanted to turn on the FPGA LED an it didn't work). I compiled the FPGA VI and it completed successfully.

bellow you find the  FPGA VI block diagram and the HOST VI block Diagram

I use CRIO-9045

-Module NI 9472

-Module NI 9215

-Module NI 9421

thx.

[GerdW]

Hi bill,

what happens when you "Run" the FPGA VI after you call this "Reset" node?

[bill0w · Accepted solution]

Hi gredw,

I found the problem. because I changed the order of the modules in their slots. it's weird when running i don't get any error and in the project don't automatically update the module location.

Best regards