From 11:00 PM CST Friday, Feb 14th - 6:30 PM CST Saturday, Feb 15th, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Error 20023 "The following conditions must be met: 0 < f_low <= f_high <= fs/2."

Solved!
Go to solution
0 Kudos
Message 11 of 23
(2,011 Views)

That's the same VI as message #1 and doesn't include your attempt at turning the data into a waveform.

 

Reread the last few messages, particularly mine about you dT values and the filter frequencies.

0 Kudos
Message 12 of 23
(2,007 Views)

First of all, replace your two filters with a single bandpass. No need to clutter the diagram.

 

You are only reading 10 samples, so the information content is low and filtering such a small part seems pointless. Get rid of all the express VIs and just use one of the ptbypt filters followed by the ptbypt peak detector that gives you a true whenever a peak is encountered. See how often these occur and you got your desired information.

 

Do you have some typical (simulated or real) data?

0 Kudos
Message 13 of 23
(2,005 Views)

Oh sorry my bad. Yes i read your message very carefully and did what you said. Now the original error doesnt pop up except a new error at peak detection vi. ive attached the edited vi. thanks

0 Kudos
Message 14 of 23
(2,002 Views)

What does the new error say?  I can't run your VI without your subVI's.

 

0 Kudos
Message 15 of 23
(1,999 Views)

Yes im getting the signal from a pulse sensor through arduino to the pc

0 Kudos
Message 16 of 23
(1,998 Views)

@derek.s wrote:

Yes im getting the signal from a pulse sensor through arduino to the pc


Yes, we figured that out long ago. Are you responding to any particular posts here?

0 Kudos
Message 17 of 23
(1,996 Views)

At the peak detection vi it states Error 20013 ... Analysis: The widith must meet 0<widith<samples

0 Kudos
Message 18 of 23
(1,995 Views)

Yes yours and another person

0 Kudos
Message 19 of 23
(1,991 Views)
Solution
Accepted by topic author derek.s

@derek.s wrote:

At the peak detection vi it states Error 20013 ... Analysis: The widith must meet 0<widith<samples


On the first iteration, your collector has only 10 samples, but your width is 15.

0 Kudos
Message 20 of 23
(1,990 Views)