Does anybody know how to set up the analog input so that i can measure starting at the beginning of a sine wave and the measure for a specified time after that?
I am outputting a sine wave pulse of five cycles at 50 kHz, and need to trigger to start measuring on the beginning of that pulse and then stop at the end. After that I need to write that data to an array, can anybody help. I am using a PCI MIO E series board.
It sounds like what you are asking is to trigger the input measurement at the moment that you start the output. This is quite easily accomplished with an E series card. Just get your manual, and start digging through it. There should also be some examples of simultaneous input and output in the examples that ship with LabVIEW that will help.
