LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

Digital to Binary conversion!

Solved!
Go to solution

Are you talking from making a subVI?  Or just branching the wire so data goes to multiple places on the same VI?


GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
0 Kudos
Message 11 of 14
(708 Views)

@crossrulz wrote:

Are you talking from making a subVI?  Or just branching the wire so data goes to multiple places on the same VI?


Hello,

I am using bit Numerical control to input my decimal input. Then I am using a split number to convert that to t 16 bits and then again 2 split numbers to spilt it into two 8 bits. I want these seperate 8 bits as an input in the other VI but I can copy this whole code to the Controlling VI where I want to use these values.

Thank you.

0 Kudos
Message 12 of 14
(707 Views)
Put the code one place or the other. It would be silly to duplicate it.
0 Kudos
Message 13 of 14
(700 Views)
Solution
Accepted by Mohit1991

Hello,

Yes. I am putting whole code at same point. I found the solution by the way, I split the number 2 times and then created a control variable for each byte. Converted it to read and then built an array out of it,

Thank you for your help.

Cheers!

0 Kudos
Message 14 of 14
(697 Views)