Data acqusition with Labview using these specific cards

[Akash Kumar]

hi,

Well could you give me some guidelines how exactly should I proceed for calibration?????

In the task configuration page the input that I have set is -50m to +50m which is qlreqdy quite small.

The cut off frequency I hv set to 10Hz

Thanks,

Akash

[Jeremy_M]

Hi Akash Kumar,

To calibrate, I can do it in your task on MAX when you are configuring your task (illustration on the added file). I advise you to test your hardware by using an external signal generator on the input and see if you find the fluctuations you had before. If not , you should verify your sensor and his connections. If there is still fluctuations, you may have a hardware problem.

Regards,