DSC ver. 8.5 I cant read the properties of a shared variable from an executable Labview application

[Giannis_Stavaris]

My problem is that I create a very simple application on labview DSC 8.5.

An I/O server with only three variables . I configure this variables with High and Low Alarm setting. Alarm condition is enabled

Then with the attached  labview application I change the Hi alarm Level  of this variable and everything is working fine under labview enviroment

B U T if you run the same application on exe mode then the shared variable property does not working

Any suggestions

Giannis

Athens Greece

[johnnyt]

go here: http://zone.ni.com/devzone/cda/tut/p/id/5715 and here

http://digital.ni.com/public.nsf/websearch/04D9A85B6967EE87862571140065EEC6?OpenDocument