From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

DC Sweep using HP6632A

DC Sweep using HP6632A

‎03-21-2002 02:08 PM

Anyone out there with ideas on how to run a fixed increment DC
voltage
sweep in the range -1.5 V to 2.0 V in LabVIEW (6.0)?

The objective is to use the HP6632A, whose drivers are installed
and
tested, as an automated, variable DC voltage source which steps
through the -1.5 V to 2.0 V range with a fixed increment at a fixed
time
interval...
0 Kudos
Message 1 of 2
(2,951 Views)
Reply

Re: DC Sweep using HP6632A

‎03-27-2002 08:29 AM

All you need is a while loop with a shift register. The attached example shows how.
Message 2 of 2
(2,951 Views)
Reply