07-02-2019 07:11 AM
Hello
I'm new on labview, I want to control servo by a switch ( if it's 1 it turns 90 ° , else it stays 0°), I'm using arduino with linx, please can anyone help me ,
07-03-2019 07:57 PM
Hi Chahinez,
Could you elaborate on where you are at with development right now? What steps have you tried? Have you been able to control a servo motor yet? If not, check out the LINX - Servo Motor 1 Channel.vi in LabVIEW Example Finder to get started. You can find that VI by searching in Help>>Find Examples within LabVIEW.
Best,
David F.
Technical Support Engineer
National Instruments
www.ni.com/support