I found this tutorial for
Acquiring from Firewire Cameras using NI-IMAQ for IEEE 1394:
http://zone.ni.com/devzone/conceptd.nsf/webmain/a533e1e5a109cbce86256d8e00768814
And it says on this website:
"
Programming:
The NI-IMAQ driver will install the
User Manual and a Function Reference Manual that you can access from the Start Menu
in Windows. If you are using LabVIEW, it will also install a specific
palette of VIs that can be used to program the acquisition from
FireWire Cameras. The palette is titled IMAQ IEEE-1394. It includes
Configuration, High Level VIs, Low Level VIs, Triggering, and access to
the registers on the FireWire Camera."
The camera works fine using Measurement & Automation Explorer.
However, when I run Labview, I cannot find the palatte of VIs that I'm
supposed to use. I don't think I have it.
What should I do now? Can someone please provide with some suggestions?
I'm currently have the following software versions installed:
Labview 8.0
Measurement & Auotomation Explorer 4.0.3
NI-IMAQ for 1394 2.0.1
NI-VISA 3.6
Thanks.