LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

CanOpen with IXXAT USB-to-CAN

Solved!
Go to solution
Highlighted

Good afternoon,
 
I'm trying to make the CanOpen communication protocol between IXXAT - USB-to-CAN device and labview. So, I'm having problems defining the master / slave nodes, NMT, SDO, PDO, ... Does anyone know how to define this in a simple way in labview?
I have seen that people use the following library: http://sine.ni.com/nips/cds/view/p/lang/en/nid/202614, but is this library generic? Can I use it with IXXAT USB-to-CAN?
Is there any other way? Does anyone have an example?
 
Thank you very much for your help,

Iñaki

0 Kudos
Message 1 of 3
(1,412 Views)

I believe the NI CAN Open library only works with NI series 2 (old) devices. I've had my eye on 

 

http://sine.ni.com/nips/cds/view/p/lang/en/nid/214110

 

this add-on but haven't had a chance to try it out yet.

0 Kudos
Message 2 of 3
(1,398 Views)
Solution
Accepted by topic author iiribarbilbao

Hi

 

This will not work

you will have to download VCI driver from the IXXAT homepage.

Maybe they have there a LabView Library for CanOpen.

Or you should do a call to them and ask for support

If not you have to do it in LabView by using the LabView CVI driver

 

Regards

 

juergen 

--Signature--
NIWeek 2017: Standardized HIL Test Automation With TestStand
NIWeek 2016: Capturing ATE Requirements With Requirements Gateway

Feedback or kudos are welcome
Message 3 of 3
(1,378 Views)