I'd like to try programming a cRIO-9053 using LabVIEW NXG 5.0. I installed software using MAX, then attempted to add the system to my project using SystemDesigner. It is not discovered, so I try to add hardware by address. Here's the result: an error stating that NI Systems Management Service is not installed or running on the machine.
Solved! Go to Solution.
Turns out using the repair feature of NI Package Manager didn't fix it. But a fresh install in the following order did:
CompactRIO drivers, NI-VISA, NI-Serial
Ahh, that’ll do it! I wish it would force install in the order IDE, Modules, drivers.
always think repair is a bit of a waste of time, as much as I hate reinstalling, sometimes a necessity.
hope it’s pain free from here on 🙂