06-26-2020 12:27 AM
I'd like to try programming a cRIO-9053 using LabVIEW NXG 5.0. I installed software using MAX, then attempted to add the system to my project using SystemDesigner. It is not discovered, so I try to add hardware by address. Here's the result: an error stating that NI Systems Management Service is not installed or running on the machine.
Any ideas?
Solved! Go to Solution.
06-26-2020 04:27 AM
NI CompactRIO 20.0, RT/FPGA definitely installed?
Regards
Jono
06-26-2020 10:31 AM
Hi Jono - Thanks for the quick reply. Yes I believe I have those necessary items installed.
07-06-2020 11:55 PM
Turns out using the repair feature of NI Package Manager didn't fix it. But a fresh install in the following order did:
LabVIEW NXG
NXG RT
NXG FPGA
CompactRIO drivers, NI-VISA, NI-Serial
07-07-2020 01:17 AM
Ahh, that’ll do it! I wish it would force install in the order IDE, Modules, drivers.
always think repair is a bit of a waste of time, as much as I hate reinstalling, sometimes a necessity.
hope it’s pain free from here on 🙂
Cheers
Jono