LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

Can not select Scan Mode

Solved!
Go to solution
Highlighted

When I start a new project and select target devices, labview will always automatically select FPGA mode. According to the instruction, there should be a step to select the SCAN mode or FPGA mode. Why it does not appear in my system? Thanks

 

I used NI cRIO-9014 with cRIO-9101 chasiss. The software is NI-compactRIO 15.0.

Thanks a lot for the help.

0 Kudos
Message 1 of 3
(484 Views)
Solution
Accepted by topic author pdslabfranky
03-16-2018 01:09 PM

Hi,

 

What do you mean by "I used NI cRIO-9014 with cRIO-9101 chassis" ? How is your hardware setup ?

From what I read, I think you cannot use Scan Mode with cRIO 9101 but only with module inside the 9101 : http://zone.ni.com/reference/en-XX/help/373197G-01/target6devicehelp/supported_hardware_rt/

CLAMaxime -- Kudos are a great way to say thank you
0 Kudos
Message 2 of 3
(454 Views)

Thanks! You are correct. Chassis 9101 does not support Scan mode. But It seems like Hybrid mode is ok. 

Thanks for the help!

0 Kudos
Message 3 of 3
(450 Views)