Hi MechHead,
Were you using the 9237 I/O channels in FPGA mode or Scan Mode? Scan Mode is not currently supported on Single-Board RIO, so that type of I/O is not directly portable to Single-Board RIO. If you were using the FPGA to access your I/O, then you shouldn't have any issue getting your I/O to appear in the LabVIEW project. When using RIO, there isn't a way to show/test I/O channels in MAX for CompactRIO or Single-Board RIO. You need to build an FPGA VI to access the I/O or use Scan Mode and the Distributed System Manager if you are on CompactRIO.
Can you post a screen shot of your CompactRIO project with the targets expanded so we can see how you were using the I/O modules in your initial project? Once we see that, it will be clear if you were using Scan Mode or FPGA mode and we can see what is the next step to getting your I/O available.
Regards,
Spex
National Instruments
To the pessimist, the glass is half empty; to the optimist, the glass is half full; to the engineer, the glass is twice as big as it needs to be has a 2x safety factor...