Adding cDAQ-9189

[p0rter2000]

This was originally posted in the DAQ section. I asked to move it here to get more views.

I am having problems adding my cDAQ-9189 chassis to MAX.

The chassis shows up in MAX, but when I click on Add Device I get error -201252 as shown below in the picture. I also tried a search in MAX of network devices and nothing shows up. I tried to add the chassis manually by entering the IP address and get "The device you requested could not be found on the network"

The PC I am using is running Windows 7 and is not connected to the internet. The chassis is directly connected to the PC via ethernet cable.

I have disabled Windows firewall and have no anti-virus software running.

I have enabled DHCP in networking on the PC, but have also tried using a static IP on the same subnet - neither work.

I am able to PING the chassis and I get a response back.

I have tried cross-over cables and ethernet switches.

I read through and tried suggestions found here:

http://www.ni.com/tutorial/54485/en/

Currently I am working with NI through a service request but wanted to know if anyone has had any similar problems. 

Anyone have any ideas?

Thanks,

[nyc_(is_out_of_here)]

So as not to waste people's time, the original post is here:

https://forums.ni.com/t5/Multifunction-DAQ/Problem-adding-cDAQ-9189-in-MAX/td-p/3838979

.