A newbie first question: fpga synchronous input

[msaleh87]

Hi all

this is my first time to send a question at this forum

it is also the first time to use Labview, I am totally newbie

My problem is:

I have Xilinx Spartan 3A FPGA with a design runs at 10 MHz " derived from the 50 MHz of the On-board clock"

I want to test my design by appling inputs to the FPGA and watching the output

so how to apply predefined synchronous inputs that are synchronized to the my design clock

thanks in advance

[AdnanZ]

I am not sure what you mean by 'predefined synchronous inputs that are synchronized to my design clock'.

Elaborate on your question a little bit. What is the hardware and software setup that you have right now? Remember, the FPGA Module for LabVIEW only supports the Xilinx SPARTAN-3E XUP Starter Kit targets.

[Charlie_P]

Good Afternoon msaleh87,

What supporting hardware are you using with your Xilinx Spartan 3A FPGA?  The only NI hardware that the Xilinx Spartan 3A FPGA is found in are the sb-RIOs and the cRIO-9072 and cRIO-9074.

What Xilinx FPGA Chips Are Used by National Instruments RIO Devices?

     http://digital.ni.com/public.nsf/allkb/ED6FC9CF7B983CFD86256DCE0072E313?OpenDocument

Please elaborate on what you are trying to accomplish with this project.  Also, please give some more details (such as source, speed, type, etc.) of your predefined synchronous inputs.

[msaleh87]

Thnnks all of you 

I have this starter kit

http://www.xilinx.com/products/devkits/HW-SPAR3A-SK-UNI-G.htm

Can I use it with Labview

[Charlie_P]

Good Morning msaleh87,

Thank you for the information.  I can not find any information regarding your Starter Kit on our website.  As such, I am inclined to say that it will not work with LabVIEW.

The only Xilinx Starter Kit I found mentioned on our website is the Spartan-3E XUP Starter Kit:

     http://digital.ni.com/express.nsf/bycode/spartan3e