Hai,
Am using crio 9002 controller, 9104 chasis and 9237 strain module.
Am trying to do shunt caliberation with 9237. When i measure the resistance across the 1(S+),10(S-) terminals the resistance value is oscillating between 125-138KOhms when the shunt caliberation is off. My expectation is that i must get a open (infinite resistance) when shunt is off. Why is this behaviour.
Am making measurements in full bridge configuration (3.3 V Ex) that doesnt match with my theoritical calculations. Is there any specific manipulation to be done with the acquired mV/V value.
Any suggestions on this pleas help out. thanks for all help.
With regards,
JK
(Certified LabVIEW Developer)
Give Kudos for Good Answers, and Mark it a solution if your problem is solved.