04-17-2018 03:07 AM
Hi Lex
Can you please help me in reading temperature, im using Arduino Leonardo with MAX31855 thermocouple breakout board. I am using the same conversion logic as yours but in my case, the temperature values are flashing with random numbers like 16, 255 etc. I have attached my program can you please help troubleshoot?
Thanks
12-19-2018 06:09 AM
Do you have the excel you used as the reference for the configurations? I am trying to recreate a similar program to monitor 8 thermocouples.
Thanks,
Nathan
01-31-2019 03:55 PM
Hi guys,
I'm starting with the Labview and arduino and trying to make the TC read working, but still have pure 0 (program running with no error, but 0 as output). I use pre-defined PmodTC1, which should work the same as vi's posted before. Could please anyone explain, what the SPI channel 0 means (can't set anything else without an error)? Where to define which pins will be used for CLK and SO?
Using Arduino UNO, MAX31855, LV2018.
04-24-2019 08:28 AM
Hi Nathan,
Do you still have that example to readout the MAX31855 conditioner ??
I'm trying to implement in a myrio device.
thx
05-02-2021 07:37 PM
Can you help me for reading temperature from arduino with MAX 6675. It is also SPI and I couldn't create block diagram. I couldn't run your diagram too.
08-29-2021 02:18 PM
04-27-2023 07:42 AM
Hello,
I am trying to understand the code that you posted and I was wondering what the meaning of the binary numbers 1000 0000 0000 0000 and 1100 0000 0000 0000 is. I can't seem to figure out where they come from or what purpose they have. Any help would be much appreciated.
Thank you in advance!
Best regards,
Teresa
01-10-2024 04:21 PM
Hi hope you are well. Can i ask where are final vis located? And also can i implement this example on sbrio 9636?
01-10-2024 04:23 PM
You implemented your design on which board?
01-10-2024 08:16 PM
thank but if is possible to load the configuration vi of the max31855 iam working on it but ha have problem with my 31855 (i burn it)
i try to do it with linx