05-16-2012 10:00 AM
Hello all,
After the installation of NI-VISA drivers on my laptop, the COM ports have been disabled.I cannot upload the firmware into the Arduino Nano board. Please help me regarding this.
Thanks,
Basavaraj
05-17-2012 09:18 AM
did you check if window under your hardware manager are enable?
05-17-2012 03:20 PM
Yes I did check.The window under the device manager does not contain any COM ports.
05-18-2012 07:54 AM
make sure windows detect them and install the arduino serial drivers...
05-18-2012 10:24 AM
Thank you...i ll try n then let u know...