LabVIEW Interface for Arduino Discussions

cancel
Showing results for 
Search instead for 
Did you mean: 
Reply

Bad Sync Packet Using UNO

Solved!
Go to solution
Highlighted

Greetings Fellow wizards.

Connecting with an arduino Uno for the first time, and I can't get past the INIT VI. Looking at highlighted execution I see that it is stuck here:

Capture.JPG

Bad Sync Packet where it sits. The tx/rx LEDs are Flashing when I attempt this, and not when I don't. The UNO is functional. I've tried examples provided, and they do the same thing. I can't find anything online that helps. I've also attached the VI I'm working with . Thank you everyone in advance!

 

SPEAKS

0 Kudos
Message 1 of 4
(1,874 Views)
Solution
Accepted by topic author Speaks
04-03-2017 06:00 AM
Spoiler
I was hoping for some responses, But I think I found the solution: I have to install LIFA_Base.ino to the Arduino. My concern is that there has not been any updates for Arduino for some time, and I'm wondering if there is other more up-to-date vi's available for this application? I can't seem to find any. 

Any advice?
0 Kudos
Message 2 of 4
(1,804 Views)
Solution
Accepted by topic author Speaks
04-14-2017 07:00 PM

LIFA hasn't been updated for several years because it was replaced by LINX a couple years ago.

0 Kudos
Message 3 of 4
(1,732 Views)

Thanks Nathan. I figured that out a while ago, but continued with LIFA anyway. Its working.  

0 Kudos
Message 4 of 4
(1,725 Views)