LabVIEW Idea Exchange

About LabVIEW Idea Exchange

Have a LabVIEW Idea?

  1. Browse by label or search in the LabVIEW Idea Exchange to see if your idea has previously been submitted. If your idea exists be sure to vote for the idea by giving it kudos to indicate your approval!
  2. If your idea has not been submitted click Post New Idea to submit a product idea to the LabVIEW Idea Exchange. Be sure to submit a separate post for each idea.
  3. Watch as the community gives your idea kudos and adds their input.
  4. As NI R&D considers the idea, they will change the idea status.
  5. Give kudos to other ideas that you would like to see in a future version of LabVIEW!
cancel
Showing results for 
Search instead for 
Did you mean: 

Right-Click a Wire to Open Type Definition

You can open a type definition by right-clicking a diagram terminal, constan, or front panel control, but it is not possible to get to a type def file just from a wire.  There are a lot of times where I'm working on a diagram that uses a type definition that is only exposed as a wire.  Right now, the process of getting to the type def is to create a temporary constant from the wire, then right click the constant.  It would be nice to make it easier to get to the type def.  And of course, I would like to have the same functionality for LabVIEW classes.

select.png

2 Comments
Member

I think this has been suggested before. Still a great feature to have though.....

Community Team
Status changed to: Duplicate