LabVIEW Idea Exchange

About LabVIEW Idea Exchange

Have a LabVIEW Idea?

  1. Browse by label or search in the LabVIEW Idea Exchange to see if your idea has previously been submitted. If your idea exists be sure to vote for the idea by giving it kudos to indicate your approval!
  2. If your idea has not been submitted click Post New Idea to submit a product idea to the LabVIEW Idea Exchange. Be sure to submit a separate post for each idea.
  3. Watch as the community gives your idea kudos and adds their input.
  4. As NI R&D considers the idea, they will change the idea status.
  5. Give kudos to other ideas that you would like to see in a future version of LabVIEW!
cancel
Showing results for 
Search instead for 
Did you mean: 

Allow switching only one input wire (or: a more forgiving Scissor\Switch-A-Roo tool)

CTRL+Click on an input is a great little tool to switch the input.

 

However, it only works when both inputs are wired. Often (, I or QD connected a wire wrong,) I feel like switching the input, before wire-ing the 2nd. Only to find it doesn't work...

 

Having to connect the 2nd wire just seems to disrupt the flow, being focused on the first input. Being forced to make things worse (connect two wrong wires) before being able to make it right just feels itchy to me.

Switch one wire.png

 

It's a minor thing, but I never understood why it would be limited to 2 wires.

6 Comments
Member

A related idea I had is to use the scissor tool to allow you to move a wire that's already attached to a terminal. This could work even when there are more than two inputs on a node. Hold <CTRL>, and click-and-drag a wire currently connected to its original terminal to a new terminal.

 

  • If the new terminal has no wire already attached, nothing else needs to be done.
  • If the new terminal is already wired, one of two things could happen:
    1. Swap the wire from the new terminal at the same time so it works somewhat like the scissors tool does now.
    2. Hold <ALT> or <SHIFT> (I haven't checked yet to see what key is still available) and it shifts all wires between the new and original terminals such that the closest one to the original moves to the original, and the others shift down.

With point #2, it may only make sense for some nodes (i.e. expandable nodes like the Concatenate Strings or Build Array, etc).

Proven Zealot

I added my kudos.

Knight of NI
Proven Zealot

I should've gone to check. Thanks, RavensFan.

Example Gatekeeper
Trusted Enthusiast

>I should've gone to check. Thanks, RavensFan.

 

I did check, for "switching", "scissors", "switch-a-roo", "inputs", "wires" but not for "swapping", "connection", "switcheroo" or "terminals"...

 

Anyway, it's in the spotlight again!