03-17-2016 04:23 PM
Hello everyone,
I'm using a NI 9501 C Series stepper drive module & NI CompactRIO real-time controller and chassis to controle a stepper motor.
I installed all NI-RIO Device Drivers, and configurated Real-time compactRio in MAX.
But whene I open a new project and try to add cRio Real time in targets and devices I can't find it!
any solutions?
03-18-2016 06:20 AM
Hi Coffeee,
So you definately have the real-time module installed as obviously it shows some real time targets just not cRIOs.
This sort of suggests that LabVIEW doesn't see the RIO driver (I believe). You must have it installed if you can see it in MAX but try repairing the installation or make sure the version you have installed supports the version of LabVIEW you have.
Cheers,
James