LabVIEW Embedded

cancel
Showing results for 
Search instead for 
Did you mean: 

Command mode for HIH Series on Honeywell HumidIcon

Hi guys,

 

i'm working with the sensor HIH8000 to measure Humidity and Temperature. 

But my problem is i can not enter Command Mode. It is said: Command mode can only be entered before 3ms or 10ms Command Window expired( right after power on). I don't know how to get into this 3 or 10ms Command Window. 

 

Here is my project, if you can take a look. 

And the Command mode datasheet for the sensor 

https://sensing.honeywell.com/command-mode-humidicon-tn-009062-3-en-final-07jun12.pdf

0 Kudos
Message 1 of 2
(155 Views)

Hello,

 

Maybe You can find helpful information in this datasheet. There are information about Using Command Mode since 10 point (page 24).

0 Kudos
Message 2 of 2
(23 Views)