LabVIEW E.N.A.B.L.E.D Discussions

cancel
Showing results for 
Search instead for 
Did you mean: 

Check the torque of a dynamometer

I'm a bit new to LABVIEW, I really need your help.

 

As part of my internship, I therefore have a dynamometer to measure thrust and torque & a motor and its variator (Setpoint voltage -10V 0 rpm _ + 10V 3000 rpm I must therefore monitor the torque channel more particularly (the torque must remain less than 10 N.m if the engine is higher than the engine is off)

 

As part of my internship, I want to create a system that will allow me to stop an engine as soon as the torque exceeds the threshold of 10 N.m.

 

Hardware: I have 1 PXI 4331 PXI 6358 analog output bridge card Thank you for your help I'm counting on you

0 Kudos
Message 1 of 1
(132 Views)