03-25-2018 10:24 AM
I have connected the oscilloscope to the computer,and downloaded the oscilloscope's driver to control it.My problem is I want to show 100 cycles of signals on the screen,but when I run the VI,it automaticly show only two cycles on the screen.What should I do?
03-25-2018 06:03 PM
03-25-2018 06:23 PM
Hello,here is the link to the driver and the vi.
Thankyou very much.
03-26-2018 06:20 AM
What is the frequency of the signal you are trying to capture? You have to use that to determine how many data to capture. The time you have to capture is T = (# cycles)/(Frequency of signal). So if you want 10 cycles of a 10Hz signal, you have to get 1 second worth of data.
03-26-2018 08:17 AM
I want to get 200 cycles of a 50kHz signal.My question is that I don't konw how to modify the oscilloscope’s driver.