05-20-2011 04:00 PM
I am using SR830, and planning to use the TTL out put (at the rear panel) as a trigger source to synchronize data collections. However, this output generates a TTL train, can any here tell me it is possible to exaggerate one TTL pulse one time? If not, we have to buy a simple TTL generator with labview compatibility.
Thanks
05-23-2011 02:00 PM
Hello,
Basically from reading the SR830 Datasheet, the TTL out at the rear panel is used to sync phase with external devices. Therefore it is a continous square wave. You may have to purchase a seperate device that can do TTL triggering. The National Instruments USB-6009 is a possible solution that works with labview.
Regards,
JVP