Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Showing results for 
Search instead for 
Did you mean: 

*RST Command on a E5071C

Hi,

 

Does anyone know if the *RST command affects the calibration of a E5071C?  I cannot find the answer anywhere.

 

Thanks in advance.

0 Kudos
Message 1 of 3
(1,082 Views)

I think it would be best answered by the manufacturer - you would get better visibility on Keysight forum than NI forum.

Santhosh
Soliton Technologies

New to the forum? Please read community guidelines and how to ask smart questions

Only two ways to appreciate someone who spent their free time to reply/answer your question - give them Kudos or mark their reply as the answer/solution.

Finding it hard to source NI hardware? Try NI Trading Post
0 Kudos
Message 2 of 3
(1,055 Views)

Most of the newer instruments will not lose their calibration information with basic commands like *RST.

 

If you saved (or not) different settings for any of these values listed in the manual in Appendix C on page 633 then it will default back to the factory settings for those Cal settings; however, those saved Cal settings can be recalled back as your desired settings.

Help the Community (and future reviewers) by marking posts as follows:
If it helped - KUDOS
If it answers the issue - SOLUTION
0 Kudos
Message 3 of 3
(1,043 Views)