Home Community Discussion Forums Most Active Hardware Boards Instrument Control (GPIB, Serial, VISA, IVI) Topic

Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

After installation of Visa runtime my mouse is moving with COM data

Solved!
Go to solution

After installation of Visa runtime my mouse is moving with COM data

‎05-12-2015 08:47 AM

I'm sorry, I don't know anything about Labview I'm just using prepared GUIs.

 

After installation of the Visa540 runtime my mouse is moving everytime I get data from the COM1. How can I switch this off?

0 Kudos
Message 1 of 3
(4,238 Views)
Reply
Solution
Accepted by topic author LippertC

Re: After installation of Visa runtime my mouse is moving with COM data

‎05-12-2015 09:18 AM

Are you using a USB-Serial adapter?  Was the device sending data during the computer's boot up?  Was the device sending data while the USB adapter was being plugged in?

 

This is likely a Windows issue.  If you connect up a serial device (USB-Serial adapter anytime or a build-in/PCI serial port at bootup) and the device is sending data, then Windows will think that the serial device is a mouse.

GCentral
There are only two ways to tell somebody thanks: Kudos and Marked Solutions
Unofficial Forum Rules and Guidelines
"Not that we are sufficient in ourselves to claim anything as coming from us, but our sufficiency is from God" - 2 Corinthians 3:5
0 Kudos
Message 2 of 3
(4,229 Views)
Reply

Re: After installation of Visa runtime my mouse is moving with COM data

‎05-12-2015 09:57 AM

sometimes it can be very easy 🙂

0 Kudos
Message 3 of 3
(4,222 Views)
Reply