I'm getting an error with my RIO (Init:FAIL DAQ2, FPGA_Init()-Error:-61024)

[Ex-NISH2]

In reference to this older post: http://forums.ni.com/t5/IF-RIO/I-m-getting-an-error-with-my-RIO-Init-FAIL-DAQ2-FPGA-Init-Error/td-p/...

I am experiencing the same problem again, after so long.

This time happens on a 3rd party chassis.

I am controlling NI-7965R over MXI express from my laptop.  It works well with NI 1062 chassis, but when I changed to a 3rd party chassis, I got this -61024 error when opening any FPGA reference.

My system:

Win 7 32bit

VISA 5.2

NI-RIO 12.0

NI FlexRIO 12.0

LabVIEW 2012

Any clue?

Thanks.

[PJ_Cell]

I was getting a -61024 error opening the FPGA on a 9146 Expansion chassis.

Eventually I found that if I input a constant to the 'Resource Name' of the Open FPGA Reference and set it to the 9146 the problem went away.

I had tried all the previous suggestions with no luck.

I am using LV 2013 with the 'NI CompactRIO 13.0 - August 2013' software package.