Running startup.rtexe on Raspberry Pi

[ss52642]

I am using LV2020 with the LINX toolkit installed from VIPM. I have a vi that will toggle a digital line which is connected to an LED. When I run the vi in development, everything works and my LED will blink. I can build the vi into a startup.rtexe and run it a startup without any problems. However, my program is not running because the LED does not blink. I have provided screenshots of the version of software I am using and what is installed on the pi.

Any ideas on why the rtexe is not running?

[DavidWilt]

To clarify, your code works without a GUI, correct?  Code running on a Raspberry Pi does not have a GUI.  The GUI will work when you run the VI in development but not when deployed.

Also, can you clarify what you mean by build a startup.rtexe?  I assume you are trying to deploy your code to the Raspberry Pi through a LabVIEW project and telling it to run on startup.  If this is not what you are doing please clarify.

[ss52642]

My code works without a GUI. Yes, I am trying to deploy my from the build spec in my project.

[ss52642 · Accepted solution]

I think I have figured it out. The version of labview I am using is 2020 but not SP1. I copied my project over to a computer with LV2020 SP1 and I was able to build and deploy my startup.rtexe from the project.

[DavidWilt]

Interesting ... I am not sure why that would resolve your issue.

[Smart_Li]

I have same problem, and my labview version is NI LabVIEW 2020 SP1 (32-bit), still has save problem, very strange.