hi all,
i had posted this question before but no one replied so i am posting it as a new message.
i am using labview 7.1 and wanna use fp-1000 and fp-tc-120(2 of them) to measure 16 temperature values from t-type thermocouples.
i connected the fieldpoint hardware with labview through RS-232 and also installed fieldpoint 5.01(with support for labview 7.1) in my system. but MAX does not detect the device. why is this happening. i checked the port settings and they are fine.
if the following info helps then i must mention that a pci-gpib card and a scxi daq system is also attached to my pc. i also made sure that the addresses are different for each one of the hardware devices.
something more, previously i was using labview 8.2 on which the device was working fine. but i had to migrate from one pc to another on which there is labview 7.1 and i cannot install labview 8.2 on this system. so please let me know what to do?